sjteo: I have loads of dead arduino in my office that were accumulated when I was away. I think we should set up a best practices.
Quick Links:
- Method #1: Shorting I/O Pins to Ground VERY COMMON PROBLEM!
- Method #2: Shorting I/O Pins to Each Other VERY COMMON PROBLEM!
- Method #3: Apply Overvoltage to I/O Pins
- Method #4: Apply External Vin Power Backwards
- Method #5: Apply >5V to the 5V Connector Pin
- Method #6: Apply >3.3V to the 3.3V Connector Pin
- Method #7: Short Vin to GND
- Method #8: Apply 5V External Power with Vin Load
- Method #9: Apply >13V to Reset Pin
- Method #10: Exceed Total Microcontroller Current VERY COMMON PROBLEM!
|
No comments:
Post a Comment